Here's just a small sampling of the finished parts we have processed:

orthoform control vs ep niti roughness.jpg

Nitinol Archwire

We improved smoothness on orthodontic archwire for medical/dental manufacturer.

NiTi wIRE ROUGHNESS IMPROVEMENTS

Quantitative analysis carried out on four manufacturers orthodontic archwires as electropolished by GMOS carried out.  Significant increases in finishing were observed and a smoother surface produced as per our electropolishing Nitinol Wire process.

Electropolishing of nitinol wire suitable for orthodontic archwires has been achieved, and a quantitative assessment of the improvement in surface roughness has been made. Due to the lack of replication, this can be considered indicative only at this stage; further trials using replicates should be undertaken in order to determine whether these results are repeatable and consistent.

Electropolishing of nitinol wire suitable for orthodontic archwires has been achieved, and a quantitative assessment of the improvement in surface roughness has been made. Due to the lack of replication, this can be considered indicative only at this stage; further trials using replicates should be undertaken in order to determine whether these results are repeatable and consistent.

titanium anodising MEDICAL DEVICES

We anodise titanium products for medical device industry as per our validated processes.

 

A blue, and gold colour produced on a Titanium workpiece (top left and top centre).  An electropolished Titanium workpiece (top right) and a Grey anodised Titanium workpiece (bottom centre).

A blue, and gold colour produced on a Titanium workpiece (top left and top centre).  An electropolished Titanium workpiece (top right) and a Grey anodised Titanium workpiece (bottom centre).